Been a while since I was at that load, but I do know you cannot
transmit CW without VOX on. Several rigs I have used do this when
using their internal keyers.
What happens to me, since I use VOX in RTTY for keying, then go to
SSB, and turn VOX off, then go to CW and VOX is off.
According to
John Gaynard wrote:
Am I correct in thinking that you cannot be/should not be in
SEMI mode unless VOX is turned on. I am on firmware level 2.38. Without
VOX or QSK turned on, you should not be able to put the rig in transmit
mode
by touching the key.
You CAN transmit by touching the
Good point, I had heard of folks using a foot switch for PTT instead
of VOX, but never tried it. Have to check that out at some point. I
just look forward to when I can force SSB Vox to always be off. Tired
of switching modes and finding out that the Vox is on when the phone
rings and the
, 2009 8:57 AM
To: Elecraft Discussion List
Subject: Re: [Elecraft] CW and VOX
Been a while since I was at that load, but I do know you cannot
transmit CW without VOX on. Several rigs I have used do this when
using their internal keyers.
What happens to me, since I use VOX in RTTY
Of David Wilburn
Sent: Tuesday, April 21, 2009 8:57 AM
To: Elecraft Discussion List
Subject: Re: [Elecraft] CW and VOX
Been a while since I was at that load, but I do know you cannot
transmit CW without VOX on. Several rigs I have used do this when
using their internal keyers.
What happens
List
Subject: Re: [Elecraft] CW and VOX
If the rig is in Data mode, AFSK and VOX is turned on, then switch to
SSB mode VOX is on. Turn VOX off and switch back to Data mode, and
VOX is off.
I don't do FSK. I didn't do RTTY till I got the K3, and am
very happy
with the AFSK
You are correct, I do not have an interface. I stumbled across some
setup for N1MM when I first got the K3 that used OFF-DTR. So I have
never mucked about with that, since it was working.
What do I set the rig to? I'm not sure what the difference between
RTS-OFF and OFF-RTS is. I'll go
-
From: elecraft-boun...@mailman.qth.net
[mailto:elecraft-boun...@mailman.qth.net] On Behalf Of David Wilburn
Sent: Tuesday, April 21, 2009 11:25 AM
To: Elecraft Discussion List
Subject: Re: [Elecraft] CW and VOX
If the rig is in Data mode, AFSK and VOX is turned on, then switch to
SSB
Wilburn
Sent: Tuesday, April 21, 2009 3:52 PM
To: Elecraft Discussion List
Subject: Re: [Elecraft] CW and VOX
You are correct, I do not have an interface. I stumbled across some
setup for N1MM when I first got the K3 that used OFF-DTR. So I have
never mucked about with that, since
Yesterday, suddenly my K3 had no RF output on CW. It had been a few days
since I was on so I was kind of mystified since it worked fine last week.
The TX light was flashing, and I could hear the TX relay in the PW-1 amp
clicking. In desperation, I went to SSB mode and there was full output
power
10 matches
Mail list logo
