Don, I changed the setting to "Y," and it instantly jumped back on
frequency and everything is fine again. As always, I really appreciate
your expert and responsive help.
Dick, K0KK
On Mon, Jun 29, 2015 at 12:13 PM, Don Wilhelm wrote:
> Dick,
>
> With the K60XV installed, do your have the menu
Dick,
With the K60XV installed, do your have the menu for d10 set to "Y" - i
needs to be that way or CAL PLL will fail as you stated.
The initial frequency for CAL PLL is in the 12,960 to 12.990 range.
Your TP1 reading also says that the frequency the K2 is trying to tune
to is near 6350 kHz
On a K2, the freq display is way, way off; e.g., on 40 meters it's really
receiving about 0.5 mHz lower. I tried to run CAL PLL but get INFO 232.
The PLL process appears to start, momentarily displaying 11,27164 mHZ,
then aborts in about a second with the INFO 232 error. I'm absolutely
positive
Jason,
During CAL PLL, Error 232 means that the firmware is not properly
reading the frequency. Aside from the obvious solutions of not being on
40 meters, and forgetting to connect the counter probe to TP1, It could
be an indication that the counter probe is not working properly, or not
eno
Hello everyone,
Well I am to the point of VFO Linearization in my assembly of the K2. When
I attempt the steps I am getting an info 232 error. I have checked to insure
that that I have the freq. probe attached to the correct point and that I am on
the correct frequency. This is the first
5 matches
Mail list logo
