Mike Downs-2 wrote:
I get an ERR TXG message after running the high power TX gain procedure on
12, 15, and 17 meter bands. However, both the K3 and my wattmeter show 50
watts output in each case. This error message does not show up on any of
the other bands, and it does not show up when
I get an ERR TXG message after running the high power TX gain procedure on 12,
15, and 17 meter bands. However, both the K3 and my wattmeter show 50 watts
output in each case. This error message does not show up on any of the other
bands, and it does not show up when operating on any of the
I have K3/100 #757 using firmware 1.88 MCU and 1.70 DSP.
When trying the Low-Power (5W) Transmitter Gain Calibration, it works on 80 and
20 meters, but on all other bands I get an ERR TXG message.
The Synthesizer Calibration and Reference Oscillator Calibration (using WWV
zero beat) run OK.
I
Hi John,
did you turn it on in the firmware? Easy to enough overlook...
Page 42 - OWNER’S MANUAL
Revision C1, November 18, 2007
Option Module Enables
K3 options can be installed at any time. Once an
option has been installed, use
Hi Toby -
Yes, I did turn the KPA3 on, but thanks for the hint. I should also add
that all my filters have the correct offsets set (with - signs...), and I
have the 2.7 KHz filter set as the transmit filter for all modes.
I should probable reiterate that the radio calibrates fine on all
Thanks for the reminder to put K3 in the Subject: line
I just installed the KPA module and attempted to do the High Power Gain
Calibration procedure at 50 Watts. But all that happens is that I get 0
Watts indicated and a ERR TXG message. Any idea what is going on? Manual
says to refer to
6 matches
Mail list logo