Are you powering the P3 from the K3S? May have blown an internal fuse
in the K3S 12V aux feed.
KPA500 does not power on. Is the switch on the back ON?
Yes, recent WSJT-X update did change some of the TX audio level values.
You will need to check the SPKR value on your computer, about 30% is
I think that's it! Thanks
Bret/N4SRN
--
Sent from: http://elecraft.365791.n2.nabble.com/
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailma
I am not sure if you are trying to power up the P3 with the K3 off, but
If you have the P3 powered from the K3 and have the internal jumper set
to power on with K3. Then the P3 will only come on when you power up
the K3.
Just a thought.
Rich
On 12/7/2019 11:13 AM, MaverickNH wrot
Our downstairs, including my shack, was being remodeled and I just put my
system back together.
The good news:
1. K3S runs and I can RX FT8 on WSJT-X 2.1.2 - CAT works fine
2. Remote ATU works when I hit TUNE on the K3S - SWR read goes to 1.0 (I
have a Directional Coupler/Panadapter TX Sensor 1.8
4 matches
Mail list logo