to the latest
> firmware.
>
> Have fun es gud dxing -- Don N4HH K3/100 #83
>
> -Original Message-
> From: elecraft-boun...@...
> [mailto:elecraft-boun...@...] On Behalf Of VE3NFK
> Sent: Sunday, April 27, 2008 3:15 PM
> To: elecr...@...
> Subject: Re: Re:[Elecr
when
you are in this menu mode. You might want to consider updating to the latest
firmware.
Have fun es gud dxing -- Don N4HH K3/100 #83
-Original Message-
From: elecraft-boun...@mailman.qth.net
[mailto:elecraft-boun...@mailman.qth.net] On Behalf Of VE3NFK
Sent: Sunday, April 27, 2008 3:1
the above is not going to solve
your problem. If this is true, the 8 pin plug on your mic is likely wired
in some strange way.
Please give it a go and report back.
As usual, YMMV. Have fun - ' 73 es gud dxing -- Don N4HH K3 #83
-Original Message-----
From: [EMAIL PROTECTED]
[mailto:
John:
Go top page 49 [Menu Functions] of the manual (rev c). Read what it says
in the Main Menu Table under MIC SEL entry.
73,
Ken K3IU
VE3NFK wrote:
Hi I have sn 709 - I have my Heil HC4 from my TS-2000 8 pin conn - when I
plug it into the K3 - I hear noise from the
Hi I have sn 709 - I have my Heil HC4 from my TS-2000 8 pin conn - when I
plug it into the K3 - I hear noise from the MICROPHONE???
The 'manual' says: " to select front or rear panel microphone AND to turn
BIAS on/off, use the MAIN:Mic SRC menu entry..
My firmware 1.78 only shows: MIC SEL
Well, it might go so far back as SN#671. I'm brand new at this, so I have
spent the past 12 hours trying to figure out what I'm doing wrong. My Heil
pro-set plus plugged into a kenwood adapter into the front. With RP.H it
works fine, FP.H/L As soon as I plug in the stereo headphone part into t
This is a known problem with the Rev B front panel artwork. I had the exact
same problem with a MH2 mike when I first used my K3/100 SN 729 a week ago on 6
meters to contact a local friend who is a well-known VHF and HF DXer and
contester. Unfortunately it did not make a good impression! Ther
Sure sounds like RF getting into the mic circuit but to prove it check to
see if the 'feedback' distortion occurs on 160 meters where, normally, RF is
far less intrusive and/or with reduced power output. I use my MH2 with my
K3 with Mic Sel set to ' FP.L bias ' because I found that the FP.H
8 matches
Mail list logo
