Motorcycles
From: elecraft-boun...@mailman.qth.net on
behalf of Keith Trinity WE6R
Sent: Monday, April 6, 2020 4:32 PM
To: elecraft@mailman.qth.net
Subject: Re: [Elecraft] K3 - NOT K3S - issue: TX Calibration fails on 6m only
Could be a burned trap on the KAT3 (most
Could be a burned trap on the KAT3 (most likely). Just jumper the coil,
L10 and it will bypass a burned capacitor. The trap was found to be
redundant.
Make sure 6m is on the correct antenna not 2.
In TUNE, does it really have High SWR?
Set ATU to BYP for any tests using dummy load.
Make sure
Thankyou. I'll check those.
Chuck KE9UW
c-haw...@illinois.edu
Sent from my iPad
> On Apr 6, 2020, at 2:43 PM, Howard Stephenson wrote:
>
> Try CONFIG TXGN
> It's listed in the manual under the CONFIG Menu
>
> values can be
> If you are having issues with TX Gain on 6M only check the IF
Try CONFIG TXGN
It's listed in the manual under the CONFIG Menu
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list:
Other than using a computer, is there a menu item where the tx calibration
values can be seen?
Tha manuals are pretty much assuming that you have a computer and still have
the one that you did the calibration on.
Chuck Jack Hawley
KE9UW
Sent from my iPhone, cjack
> On Apr 5, 2020, at 7:24
Jim,
If I am not mistaken, if the K3 Utility TX Gain calibration fails on any
band, no calibration information is stored in the K3. If you do it
manually, it will save on a band by band basis.
73,
Don W3FPR
On 4/2/2020 9:12 AM, Jim Spears wrote:
I am helping a friend upgrade an older
ey
c-haw...@illinois.edu
Amateur Radio, KE9UW
aka Jack, BMW Motorcycles
From: elecraft-boun...@mailman.qth.net on behalf
of Jim Spears
Sent: Thursday, April 2, 2020 8:12 AM
To: elecraft@mailman.qth.net
Subject: [Elecraft] K3 - NOT K3S - issue: TX Calibration fails
, BMW Motorcycles
From: elecraft-boun...@mailman.qth.net on
behalf of Jim Spears
Sent: Thursday, April 2, 2020 8:12 AM
To: elecraft@mailman.qth.net
Subject: [Elecraft] K3 - NOT K3S - issue: TX Calibration fails on 6m only
I am helping a friend upgrade an older
I am helping a friend upgrade an older K3/100 (s/n 798) after he recently
acquired it from estate of a SK. I have brought firmware forward one or two
versions and installed the KIO3B board set. The radio has main RX only and
the KSYN3A upgrade. It does have the KANT3 antenna tuner.
I ran
9 matches
Mail list logo
