No, RF Gain calibration.
On 6/4/2020 2:48 PM, Nr4c wrote:
Oh, “S” Meter Cal
Sorry!
Sent from my iPhone
...nr4c. bill
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help:
Hi,
Bah! Someone got me confused. I WAS trying to do the RF Gain (not RX or TX).
Anyway. There is a bug with the Mac version of the K3 Utility. I dusted of my
old POS Windows laptop, fired it up, updated the K3 Utility and waited the
hour+ it needed to update Windows 10. I was able to perform
Sorry,
Typo, I am trying to do the RX (not RF) calibration.
My bad. I tried a different USB cable and my K3s Utility was out of date so I
updated that but there was no change. Still have the same error.
/randy
> On Jun 4, 2020, at 3:45 PM, Nr4c wrote:
>
> Exactly what are you trying to do?
Oh, “S” Meter Cal
Sorry!
Sent from my iPhone
...nr4c. bill
> On Jun 4, 2020, at 4:57 PM, Randy Diddel wrote:
>
> Hello again,
>
> I sent this message a few days ago but did not get a single response. I have
> emailed Elecraft support but due to COVID-19, I am not sure when I will get a
>
Exactly what are you trying to do?
The RF GAIN Calibration is done with the transmitter and a “Dummy” load. No
need for the XG3. Look in manual around page 52.
Sent from my iPhone
...nr4c. bill
> On Jun 4, 2020, at 4:57 PM, Randy Diddel wrote:
>
> Hello again,
>
> I sent this message a
Hi David,
I will try a different USB cable although I am using the brand new one that
came from Elecraft with the XG3 which arrived a few days ago. I will check the
k3 Utility version.
Thanks for the response!
73
K5RHD
/randy
> On Jun 4, 2020, at 3:23 PM, David Fleming wrote:
>
> Hi
Hi Randy,
You are using an older revision of the K3 Utility. The first thing I would try
would be to download the most current revision of the Utility (1.19.9.6) and
see if that solves the problem. If this doesn’t help, I would suspect that your
usb/serial link between your Mac and the K3s may
Hello again,
I sent this message a few days ago but did not get a single response. I have
emailed Elecraft support but due to COVID-19, I am not sure when I will get a
response from them. So here is my message again:
Anyone?
I still have not been able to figure this out.
73
K5RHD
/randy
Hi all,
I am trying to do the RF Calibration test using my new XG3. I am getting the
error below. I have all firmware up to date on the K3s and the XG3. I even
tried reloading the firmware on the K3s just to see if that worked. Of course
turning it off and back on again did nothing either.
9 matches
Mail list logo