can
have 4000 N of linear force on the carriage and I think that's more than
enough.
Hope this helps!
El lun, 25 de dic. de 2023 21:08, Linden via Emc-users <
emc-users@lists.sourceforge.net> escribió:
Hello All,
In the early stages of converting a 13 x 24 inch manual Chinese
Hello All,
In the early stages of converting a 13 x 24 inch manual Chinese
lathe to run with Linux CNC.
I have 2 questions regarding replacing the Z axis lead screw with a 3205
ball screw:
What I am thinking is mounting the fixed end in a pillow block at the
head stock end of the
er.
>John
>
>> -Original Message-----
>> From: Linden via Emc-users [mailto:emc-users@lists.sourceforge.net]
>> Sent: March-22-23 8:53 AM
>> To: Enhanced Machine Controller (EMC)
>> Cc: Linden
>> Subject: [Emc-users] Conformal coating available in North Am
Hello All,
I'm looking for some help. Dose any one here have any experience with
Conformal coatings for PCB boards. I'm looking for something available in North
America in small quantities (approx 1 liter) What I have is a little PCB with
through hole resistors soldered to it these get
Well said. I see the same both in Europe and North America in all the various
fields of industry I deal with.
On January 25, 2023 2:11:20 p.m. PST, Chris Albertson
wrote:
>The root of the issue here is that LCNC is not a product. It is a
>development environment where a person can, with some
Thanks Chris I hadn't seen this 7i92. I was just looking at 7i76 as that was
what I was familiar with.
May have to put in a Mesa order;-)
Linden
On January 19, 2023 9:25:30 a.m. PST, Chris Albertson
wrote:
>This card seems to be in-stock at the Mesa website. I'd go with Ethernet
>because
Thanks for the suggestions.
Looks like finding an off the shelf pc will be more of an adventure than
I had hopped.
Found a 25pin sub d and a have made a ribbon cable header out of a old
floppy cable. It is not optimal but it should work for a while and I
know the latency of the pc I have is
Does any one have suggestions for a reasonably priced and available fan
less pc with a parallel port that I can use with linux cnc to go with my
gecko 540?
Looking to spend under $300 if possible with shipping
My original old dell gave up and died several years ago. The pci 1
parallel port
