Suddenly I have problem with homing my z axis, as it reaches switch it back's
off as it supposed to, but then it doesn't stop on programmed home offset
instead it runs over it and keeps searching with its delatching velocity...
Next problem occurred after update to 2.7.0 pre, as when I restart
Commenting out LP line in modules doesn't help, and also uncommenting install
parport_pc /bin/true didn't in /etc/modprobe.d/linuxcnc.conf
Next problem occurred after update to 2.7.0 pre, as when I restart linuxcnc
i'm getting error saying:
Debug file information:insmod: error
On Sat, Sep 06, 2014 at 03:12:56PM +, Tomaz T. wrote:
Next problem occurred after update to 2.7.0 pre, as when I restart
linuxcnc i'm getting error saying:
Debug file information:insmod: error inserting
'/usr/realtime-2.6.32-122-rtai/modules/linuxcnc/hal_parport.ko': -1
Device or resource
I tested for the hal_parport device or resource busy problem but was
unable to reproduce it.
I tested on a debian 7 system recently installed from the hybrid.iso. I
tested at a master branch revision which describes as
v2.6.3-659-gce43af0 (today's master branch) using a standalone test
script in
On Saturday 06 September 2014 12:00:20 Tomaz T. did opine
And Gene did reply:
Commenting out LP line in modules doesn't help, and also
uncommenting install parport_pc /bin/true didn't
in /etc/modprobe.d/linuxcnc.conf
If the std linux parport driver is available, and udev loads it, the
On Sat, Sep 06, 2014 at 03:21:01PM -0400, Gene Heskett wrote:
On Saturday 06 September 2014 12:00:20 Tomaz T. did opine
And Gene did reply:
Commenting out LP line in modules doesn't help, and also
uncommenting install parport_pc /bin/true didn't
in /etc/modprobe.d/linuxcnc.conf
If
