Last night I finished the wiring phase of my project of replacing the
old Chopper Drivers and Vexa steppers on a DM4S mini mill with a
Gecko G540 and KL23H284-35-4B stepper for the Z axis and 2
KL23H276-28-4B steppers for the X and Y axis.
EMC picked everything up quite nicely - I still
Is the ground on your relay card truly a ground or is it a common?
If it is a common - put the power supply + wire on the common and turn
the relays on by grounding the relay output line. Some DC relays
will work with either polarity, some will not.
Dave
Michael Jones wrote:
Last night I
Michael Jones wrote:
Last night I finished the wiring phase of my project of replacing the
old Chopper Drivers and Vexa steppers on a DM4S mini mill with a
Gecko G540 and KL23H284-35-4B stepper for the Z axis and 2
KL23H276-28-4B steppers for the X and Y axis.
EMC picked everything up
On Dec 5, 2009, at 1:04 PM, Stephen Wille Padnos wrote:
Michael Jones wrote:
Last night I finished the wiring phase of my project of replacing the
old Chopper Drivers and Vexa steppers on a DM4S mini mill with a
Gecko G540 and KL23H284-35-4B stepper for the Z axis and 2
KL23H276-28-4B
I may have figured out the issue.. I took for granted that the
stepconf wizard would put the right values in for the step timing.
The values that come up as a default when you select a G540 device are
wrong.
What should the Step Time, Step Space, Direction Hold, and Direction
setup be
Michael Jones wrote:
I may have figured out the issue.. I took for granted that the
stepconf wizard would put the right values in for the step timing.
The values that come up as a default when you select a G540 device are
wrong.
Did you select the G540 device from the drop-down list
