On Tue, Mar 11, 2008 at 11:36:52PM -0400, Gene Heskett wrote:
> There are 2 buglets then, Jeff. The other is that stepcpnf doesn't give you
> a
> choice of mode/type for pwmgen. I had to hand edit that into the top of
> my .hal file also. I guess it assumes most are running induction motor
>
On Tuesday 11 March 2008, Jeff Epler wrote:
>On Mon, Mar 10, 2008 at 10:05:12PM -0400, Gene Heskett wrote:
>> This is something that I configured the last time I ran stepconf, so
>> theoretically, all I should have to do is hook it up and go unless theres
>> a bug in stepconf or I have some duff ha
On Mon, Mar 10, 2008 at 10:05:12PM -0400, Gene Heskett wrote:
> This is something that I configured the last time I ran stepconf, so
> theoretically, all I should have to do is hook it up and go unless theres a
> bug in stepconf or I have some duff hardware. These are pins that have not
> been
On Mon, 2008-03-10 at 22:05 -0400, Gene Heskett wrote:
... snip
> I haven't even gotten that far, this is trying to use axis to enable it
> and 'spin' it by issueing the pwm and dir sigs. I don't have the outputs of
> Steve's card even connected to the spindle controller card yet, I'm at the
>
> I haven't even gotten that far, this is trying to use axis to enable it
> and 'spin' it by issueing the pwm and dir sigs. I don't have the outputs of
> Steve's card even connected to the spindle controller card yet, I'm at the
> point of trying to get the card to actually recognize that it
On Monday 10 March 2008, Kirk Wallace wrote:
>On Mon, 2008-03-10 at 20:15 -0400, John Kasunich wrote:
>> Gene Heskett wrote:
>> > Greetings all;
>> >
>> > I'm in the process of hooking up one of Steve Stallings #106 spindle
>
>... snip
>
>> > So, what do I check next folks?
>>
>> Divide and conquer
On Mon, 2008-03-10 at 20:15 -0400, John Kasunich wrote:
> Gene Heskett wrote:
> > Greetings all;
> >
> > I'm in the process of hooking up one of Steve Stallings #106 spindle
... snip
> > So, what do I check next folks?
> >
>
> Divide and conquer. Pwmgen is known to work, so thats not likely to
Gene Heskett wrote:
> Greetings all;
>
> I'm in the process of hooking up one of Steve Stallings #106 spindle
> controllers, and have run into either a config problem, a buglet or a
> hardware problem.
>
> I thought it might be a bios vs parport thing, and when I checked, I found
> the
> bios
Greetings all;
I'm in the process of hooking up one of Steve Stallings #106 spindle
controllers, and have run into either a config problem, a buglet or a
hardware problem.
I thought it might be a bios vs parport thing, and when I checked, I found the
bios was setting it for SPP, so I changed i
