I installed 2.1 on a SanDisk 4GB Ultra (200x) for use on an Alix board.
I configured the ethernet ports using the serial connection and then
left the connection and minicom running while I did more configuration
using the ethernet webConfigurator.
Every time I would make a change to the
https://doc.pfsense.org/index.php/DMA_and_LBA_Errors
On Mon, Oct 28, 2013 at 12:18 PM, Bob Gustafson bob...@rcn.com wrote:
I installed 2.1 on a SanDisk 4GB Ultra (200x) for use on an Alix board.
I configured the ethernet ports using the serial connection and then left
the connection and
Ok, you have it nailed already - thanks much.
Bob G
On 10/28/2013 12:21 PM, Jim Thompson wrote:
https://doc.pfsense.org/index.php/DMA_and_LBA_Errors
On Mon, Oct 28, 2013 at 12:18 PM, Bob Gustafson bob...@rcn.com
mailto:bob...@rcn.com wrote:
I installed 2.1 on a SanDisk 4GB Ultra
Hi,
I am stumped on this one. I have three sites. Each one connects to
the other two via ipsec. I'm having an issue in only one direction, and
I cannot figure out what is going on.
To test, I am using the following ping command.
ping -D -s 1472 destination
Site A(10.1.0.1)
- can ping
Any thoughts??
May not answer your question, but you did ask...
I set up my first ipsec tunnel with pfSense and it has been wonderful, but I
had to set System menu Advanced Miscellaneous tab Enable MSS clamping
on VPN traffic, and set it to 1375 before I got a stable connection. Before
On 10/28/2013 02:19 PM, compdoc wrote:
Any thoughts??
May not answer your question, but you did ask...
I set up my first ipsec tunnel with pfSense and it has been wonderful,
but I had to set System menu Advanced Miscellaneous tab Enable
MSS clamping on VPN traffic, and set it to 1375
Hi;
I use primary and secondary radius server in pfsense capitive
portal,but pfsense only response primary radius
secondary radius not
working.
___
List mailing list
List@lists.pfsense.org
http://lists.pfsense.org/mailman/listinfo/list
What I observe:
When a static mapping is created for a DHCP client, the DNS forwarder
appears to NOT register the mapping (i.e. does not allow DNS resolution)
unless the client is also manually assigned an IP address.
It is my understanding that if the address value is left blank (i.e. if
