At 09:52 PM 3/28/01 -0800, Jim Mcgrath wrote:
In most cases I don't have the luxury of modifying the schematic. If possible
can you build a footprint with a multylayer pad with a drill zero? If so
build one and overlap the pads on the common point to the 2 resistors.
I would not normally
Subject: [PEDA] Overlapping Pads
Hello,
I am trying to place two resistors on a board such that
they are end-to-end and they share one common hole. So you
end up with 3 holes and either a resistor can be placed in
one side or the other to select different voltage levels.
When
What I have done for this is to create a 3 pin part (SCH and PBC) with an A
side and a B side. This should work fine.
-Original Message-
From: Afshin Salehi [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, March 28, 2001 4:21 PM
To: Protel EDA Forum
Subject: [PEDA] Overlapping Pads
Hello
To: Protel EDA Forum
Subject: [PEDA] Overlapping Pads
Hello,
I am trying to place two resistors on a board such that
they are end-to-end and they share one common hole. So you
end up with 3 holes and either a resistor can be placed in
one side or the other to select different voltage