Hi All,
Hello, I am newcomer in this group. I hope I will get and share some
experiences with you all,
My problem is the following: We purchased a VHF Motorola R-100
Repeater and we got the Codeplug and necessary cabling from Batlabs.
During programming we connected to the repeater properly
If you are running Echolink in sysop mode you can use the local
Keyline to do the keying. Another way is to do a VBScript..this is a
visual Basic Script that will allow you to change the state of a
handshake line on the 232 port. I use a freeware program called DTMF
DIAL it's small but it
Your question was: Why should I use 7 length of interconnect line
between the cavities? (think it's 1/8 wavelength)
And why are the length of the coupling cable to the t rx-line 9 and
tx-line 26?
The answer is: That is what the design calls for.
W1GAN is probably SK by now, so you will just
Must have been a serious short circuit on the 9.6V line to burn the inner foil.
I'm very surprised. Are you just missing 9.6V on various ICs, or has that foil
actually shorted to other layers? Did it take anything else with it (like the
9.6V line in the flat cable that plugs into the SSCB)?
The word from the Motorola shop that we got the repeater from was
that a lightning strike is what hosed it. We tried to bypass the
toint were the 9.6v comes in and then stops via the ribbon cable bit
all it does is get real hot and burns up the jumper. The 5v supply is
working at 5v unloaded
Hello,
I am a newbie..
I would like to know how to tap Squelch circuit in Kenwood TM 261A, ICOM 2100
and ICOM 220H
I would like to use this as COS to be inputted to squelch sensor in COR
In Alinco DR135 MKIII, it is available in the back of the RIG. It is at pin 1
(DB9 connector)
Hello Terry,
Thanks for your answer.
I never doubt about this statement I only will understand the appreciation
behind.
Today i know the difference between the couple-lines.
Its not easy to understand but now i'm instruct by W4FWG.
73
Hans-Juergen
-Ursprüngliche Nachricht-
Von: Terry
The EEPROMs in the R100 do go bad and you will get the checksum error.
The computer MUST be a 286 at 10 megahertz OR slower to work properly
with the RSS program.
Also there is an error in the programming cable that 'may' cause
problems. Change the two 2.2K resistors to 4.7K to better match the
I don't have documentation on the controller of this repeater. Does
anyone know where the adjustment is to turn up the synthesized voice on
this repeater. Any help would be greatly appreciated. If anyone has the
hardware manual for the Mark 4 CR please let me know.
Thanks 73's
Gary K2ACY
The adjustment is on the audio board. I don't have my manuals handy right
now, but can look tomorrow. Email me off list.
73,
Mike
WM4B
From: Repeater-Builder@yahoogroups.com
[mailto:[EMAIL PROTECTED] On Behalf Of garyp609
Sent: Friday, December 05, 2008 8:54 PM
To:
Am getting desperate to find one! Can someone help? Pls. reply offlist
with details.
Tnx
Jerry VE3 EXT
Jerry,
You should check the manuals available now for download right here:
www.repeater-builder.com/maxtrac/maxtrac-index.html
The complete GM300 service manual is available in five parts. Just scroll
down to the manual download section.
73, Eric Lemmon WB6FLY
-Original Message-
12 matches
Mail list logo
