Hal Murray hmurray@... writes:
normanlizeth@... said:
I also have a pair of small boards that I don't have any info on.
PCB says Trimble, 39818-00-C. The 00 is written in by hand.
There is a big chip on the bottom that says Trimble. 144 quad flatpack.
Anybody recognize that?
, 2014 10:45 PM
To: time-nuts@febo.com
Subject: Re: [time-nuts] Datum ts2100 gps error code 41: New clone ace III
Are you sure your GPS module has the correct settings of 9600 8-O-1 TSIP
IN TSIP OUT?
___
time-nuts mailing list -- time-nuts@febo.com
to be the same as per your discussion. Is
it possible to obtain the Technical Manual for this equipment ?
Thanks
Roy
-Original Message-
From: Jason Rabel
Sent: Saturday, July 26, 2014 3:04 PM
To: time-nuts@febo.com
Subject: Re: [time-nuts] Datum ts2100 gps error code 41: New clone ace III
I
normanliz...@gmail.com said:
Turns out that the original receiver was a svee6.
Let me know if you want a real SVee6. I've got 2 left. :)
---
I also have a pair of small boards that I don't have any info on.
PCB says Trimble, 39818-00-C. The 00 is written in by hand.
There is a big chip
Hal,
I may take you up on that. However, looking through the manual, it appears
that not all of that type/firmware support WRNO. Supposedly, based on my
digging, early ones did not, the later ones did.
Next step is to ensure that the number formatting output by the new clone
corresponds to the
I also have a pair of small boards that I don't have any info on.
PCB says Trimble, 39818-00-C. The 00 is written in by hand.
There is a big chip on the bottom that says Trimble. 144 quad
flatpack.
It's got more stuff on the chip, but I can't read it.
I compared against my Trimble
The GPS Health menu choice never really did anything. It will always
say Doing position fixes, error code: 1. However, the GPS Firmware and
Signal Strength menus should report back proper information.
Can you elaborate on it does not set the right time? Is it some random
time, or is it off by
Jason,
The time on the front panel of the instrument, at power on, shows Jan 1,
2014.
As you say, the gps health menu choice functions sometimes like you state,
other times I get error 41. I do also get the firmware and satellite
information.
Neither the Tracking or Lock led's illuminate.
Norm
Are you sure your GPS module has the correct settings of 9600 8-O-1 TSIP
IN TSIP OUT?
___
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
Jason,
If the device (gps) reports the firmware and satellites correctly (to the
ts 2100), I would assume so.
No other reasonable explanation exists.
Turns out that the original receiver was a svee6. Found the manual for the
gps and am comparing the default messages with the ace III.
Norm
On
Hi all!
Have a Datum ts2100 that had a failed gps receiver. Found a replacement as
a new clone. The ts2100 with the new receiver does not set the right
time, however, it does know where it is, reports the gps firmware version
and gives satellite information. Prior to this, the only message that I
11 matches
Mail list logo