Emanuel:
One can fix a specified filter during the entire mulplt session.
e.g.,
osop@queretaro:/opt/seismo/WAV$ mulplt
Filename, number, filenr.lis (all)
Continuous SEISAN data base: cont
Large SEED volume: conts
Bud archive: bud
SEISCOMP archive: scp
1
Read headers from files:
2011-11-05-2149-08S.MAN___038
Plot options: Interactive picking Return
Multi trace plot on screen, def (0)
Multi trace plot on screen (1)
Multi trace plot on screen+laser(2)
Multi trace plot on laser (3)
Continuoues on screen (4)
Continuoues on screen + laser (5)
Continuoues on laser (6)
Stop (q)
0
Low and high cut for filter, return for no filter
10 15
This will set a bandpass filter from 10 to 15 Hz for the entire mulplt
session.
Atte.
*Branden C. Christensen*
Director, OSOP
*[email protected]*
www.osop.com.pa
Volcan, Panama
On Tue, Oct 9, 2012 at 4:53 PM, Emanuel Antunes
<[email protected]>wrote:
> Dear All,
>
>
> I have searched for a solution to this problem but was unsuccessful in
> doing so. You have been most helpful in helping me solve my previous
> problem, so once again I resort to your collective expertise.
> I would like to know if it is possible to set up a default filter so that
> wavefiles are always opened with that filter when one uses mulplt or option
> “p”/“po” in eev. In order to toggle between single channel or multichannel
> modes. Alternatively, can one fix a specified filter during the entire
> mulplt session?
> Thanks in advance.
>
> Best regards,
>
>
> *Emanuel Antunes*
>
> Integrated Master Degree (MSc) in Physics Engineering
> M.Sc. Thesis - Seismology Laboratory
> Instituto Superior Técnico (IST) - Lisbon Technical University (UTL)
>
>
>
>
>
> _______________________________________________
> seisan mailing list
> [email protected]
> http://mailman.uib.no/listinfo/seisan
>
>
_______________________________________________
seisan mailing list
[email protected]
http://mailman.uib.no/listinfo/seisan
