Dear Jens, Thank you for your input. I had already looked around MULPLT.DEF for a solution, but I missed that parameter. I set the parameter to a 1-20Hz bandpass filter and it works. The only problem is that if I zoom in and out, or change to single-trace mode, the filtering dissapears. Basically it seems to open the waveforms with the filter but as soon as it re-plots it looses the filtering. I tried the FixF option but somehow it seems not to affect the output at all...
Best, Emanuel Antunes Integrated Master Degree (MSc) in Physics Engineering M.Sc. Thesis - Seismology Laboratory Instituto Superior Técnico (IST) - Lisbon Technical University (UTL) On 2012/10/10, at 07:24, Jens Havskov wrote: > emanuel > > you can also set parameter BANDPASS FILTER in MULPLT.DEF and the filter is > always on when plotting from eev with option po > > jens > > On Tue, 9 Oct 2012, Emanuel Antunes wrote: > >> Dear All, >> I have searched for a solution to this problem but was unsuccessful in doing >> so. You have been most helpful in helping me solve my previous problem, so >> once again I resort to your collective expertise. I would like to know if it >> is possible to set up a default filter so that >> wavefiles are always opened with that filter when one uses mulplt or option >> ?p?/?po?in eev. In order to toggle between single channel or multichannel >> modes. >> Alternatively, can one fix a specified filter during the entire mulplt >> session? >> Thanks in advance. >> Best regards, >> Emanuel Antunes >> Integrated Master Degree (MSc) in Physics Engineering >> M.Sc. Thesis - Seismology Laboratory Instituto Superior Técnico (IST) - >> Lisbon Technical University (UTL) Emanuel Antunes Integrated Master Degree (MSc) in Physics Engineering M.Sc. Thesis - Seismology Laboratory Instituto Superior Técnico (IST) - Lisbon Technical University (UTL)
_______________________________________________ seisan mailing list [email protected] http://mailman.uib.no/listinfo/seisan
