Start Plone in debug mode from the command prompt, if its not going
to run, it will tell you about it in great detail.
There should be documentation on plone.org or in the books telling
you how to do this.
On 28 Feb 2007, at 08:32, Chris Chambers wrote:
I have searched the lists but probably not using the right
keywords. Hence
the post.
I have installed Plone 2.5.2 using the installer which went without
a hitch
and the Plone Controller is running just fine. It says Plone has
started but
"View Plone" brings up a blank window and the ZMI button gives
"Firefox
can't establish a connection to the server at localhost:8080".
After quite a
few minutes (probably ten) Plone is stopped under the status in Plone
Controller
I'm running WindowsXP 64. I posted a question way back asking if
things ran
OK on this OS and had no reply. I assumed that things should be
fine. Maybe
the problem is Win x64 or maybe just Plone 2.5.2 install.
Where to from here?
Regards
Chris
--
View this message in context: http://www.nabble.com/Plone-
Controller-OK-but-no-Plone-running-%28Win-x64-problem-%29-
tf3307471.html#a9199864
Sent from the Plone Setup mailing list archive at Nabble.com.
_______________________________________________
Setup mailing list
[email protected]
http://lists.plone.org/mailman/listinfo/setup
--
Andy McKay
_______________________________________________
Setup mailing list
[email protected]
http://lists.plone.org/mailman/listinfo/setup
