I also had problems configuring an ISDN modem to work with STN.
My modem was a 3com ISDN TA. Everything seemed to work
right; it even dialed the ISP correctly. When it was connected,
however, it disconnected almost immediately - the same problem
you are having. I troubleshooted the problem with John but finally
had to go and buy a router because I could not afford to not have
net access on the network for any longer.
Date sent: Fri, 10 Sep 1999 23:51:01 -0700
From: "A.S. Baum, Inc." <[EMAIL PROTECTED]>
Send reply to: [EMAIL PROTECTED]
Organization: A.S. Baum, Inc.
To: [EMAIL PROTECTED]
Subject: [ShareTheNet] External 33.6K modem works but not ISDN
> Was sharing an Eicon ISDN external modem and a Practical Peripherals
> 33.6 external modem on a Win95 Server using Lantastic's Modem share.
> All the client stations using modem share were able to access both the
> ISDN modem along with 33.6 modem (of course, one a time as if the modems
> were local). They were all able to dial out with their respective
> softwares on both modems.
>
> Setup and configured STN on another box using modem on Com1. Set client
> workstations to tcp/ip and:
>
> 1) when using the external 33.6 modem everything worked fine, everyone
> in and to the web, simultaneously.
>
> 2) when rebooting STN (with another boot disk with only phone number
> changed for ISDN) and connecting external ISDN, it dials out, connects
> and then gets "hangup" with connect time of .1 min. checked the name
> and password and phone number and appears correct. Because if I just
> change the phone number back to the non-ISDN number and reboot using the
> 33.6 modem it again works fine. And this is the same dial-in number
> that was used with dial-up adpater. Even if I use the same exact
> diskette with the non-ISDN number (which should work, one would think
> only not at ISDN speeds, right?) that I had used with the 33.6 modem -
> same short connect.
>
> 3) when reconnecting external 33.6 modem after ISDN - all is fine, once
> again as expected.
>
> 4) when reconnecting ISDN back to Lantastic Server (simple plug out of
> STN and back into Server - no reboots) - everyone can use it again on
> the Lantastic Server.
>
> 5) even tried resetting ISDN modem (power out - power in) between moves
> - still dials out but gets kicked off, yet works fine on Lantastic
> Server.
>
> Obviously would like to pipe through ISDN rather 56K (which will soon
> replace 33.6 for test).
>
> Questions:
>
> 1) Does STN work with Eicon ISDN modem?
>
> 2) Any additional configuration under modem settings that I've missed,
> ie, init string other than ATZ (or nothing, as I had tried too)?
>
> 3) If modem dials out, "connect" and "got it" are returned messages what
> else should I be looking for?
>
> 4) Maybe should try another brand of ISDN, any suggestions?
>
> Any and all help would be greatly appreciated.
>
> Thanks,
> Arnie Rothenbaum
> [EMAIL PROTECTED]
>
> _______________________________________________
> ShareTheNet maillist - [EMAIL PROTECTED]
> http://www.webserv.com/mailman/listinfo/sharethenet
>
>
>
_______________________________________________
ShareTheNet maillist - [EMAIL PROTECTED]
http://www.webserv.com/mailman/listinfo/sharethenet
