Re: ShopTalk: SWB hosel depth

[Bernie Baymiller]

Pat,   The one that I built for myself used an A-flex shaft, and I like a high A or low R, so I didn't worry about stiffening it up a bit. Worked fine. Can't remember, but like many of the big heads (if you are using a 400-450cc SWB), I think the hosel bore is about an inch and a half off the ground (I know the Integra S450 is that depth.), so be sure to check your club length dry assembled.   Bernie Writeto: [EMAIL PROTECTED] ----- Original Message ----- From: Pat McGoldrick To: [EMAIL PROTECTED] Sent: Sunday, August 25, 2002 5:22 PM Subject: ShopTalk: SWB hosel depth Bernie or anyone else that has experience with these heads, I am getting ready to build a driver with this head and just realized that the hosel depth is 2" deep. Is this right? Was I suppose to receive a plug of some kind? Is it a good idea to install a trimmed piece of a .335" X 1/2" long  to reduce the insertion depth so the shaft will play softer? TIA Pat McGoldrick On Target Golf