Dave, I have measured the 8.5 degrees MV2 and I got 54 mm. The 10.5 head appears to be deeper. I will measure when I get a chance ( friend plays it and he will not part with it now, so I will have to measure next time we play together ). Regards, Charlie W. P.S. Dave, I believe I answered your question in error to Bernie ( re slice or draw tendencies). If you have not seen it I will re post. ----- Original Message ----- From: "Dave Tutelman" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Monday, September 09, 2002 9:43 AM Subject: Re: ShopTalk: 50" long Driver help
> ----- Original Message ----- > From: Charlie <[EMAIL PROTECTED]> > Sent: Monday, September 09, 2002 9:21 AM > > > >FYI, I have built 2 MV2 ( SMT's) and both were 195 Grams. > >These heads are 380cc and the 10.5 degrees appears to be > >at least 2 degrees closed and very upright. > >The SMT listed specs ( on the web ) are 56 degrees lie, > >1 closed and 199 grams. > >Great solid head and could be a good one for longer shafts. > > Charlie, > I ordered an Mv2 head, and also noticed that it was much lighter than spec. > Mine was 194g. The possibilities for a long driver occurred to me also, but > unfortunately that was not the project I had ordered it for. > > I also measured its face height at 52mm, much less than the 59mm claimed in > the specs. > > Which brings me to... > There was a discussion a short while ago about whether the Mv2 has specific > slice or hook tendencies. (For instance, the Baltusrol has been reported to > slice a lot.) Have you noticed any? > > Thanks, > DaveT > >
