Charlie, Sorry for the long delay in answering, but it's been very hectic.
* Your note arrived while I was away on a long golf weekend -- one of these 90 holes in 3 days things. * When I got back, I was most of a week catching up. I've just started as an Adjunct Professor at The College of New Jersey, and teaching a course for the first time involves a lot of preparation. Should be much easier next semester, assuming I decide to continue. I'll have my lesson presentations, homework assignments, homework solutions, etc; but for now, I have to do everything from scratch. Finally got back to the mail that arrived since then. Anyway, I did see the note that you posted, and assumed correctly that you mistakenly said it was for Bernie. Thanks, DaveT ----- Original Message ----- From: Charlie <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Thursday, September 12, 2002 2:43 PM Subject: Re: ShopTalk: 50" long Driver help > Dave, > I have measured the 8.5 degrees MV2 and I got 54 mm. > The 10.5 head appears to be deeper. I will measure when I get a chance ( > friend plays it and he will not part with it now, so I will have to measure > next time we play together ). > Regards, > Charlie W. > P.S. > Dave, I believe I answered your question in error to Bernie ( re slice or > draw tendencies). If you have not seen it I will re post. > ----- Original Message ----- > From: "Dave Tutelman" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Monday, September 09, 2002 9:43 AM > Subject: Re: ShopTalk: 50" long Driver help > > > > ----- Original Message ----- > > From: Charlie <[EMAIL PROTECTED]> > > Sent: Monday, September 09, 2002 9:21 AM > > > > > > >FYI, I have built 2 MV2 ( SMT's) and both were 195 Grams. > > >These heads are 380cc and the 10.5 degrees appears to be > > >at least 2 degrees closed and very upright. > > >The SMT listed specs ( on the web ) are 56 degrees lie, > > >1 closed and 199 grams. > > >Great solid head and could be a good one for longer shafts. > > > > Charlie, > > I ordered an Mv2 head, and also noticed that it was much lighter than > spec. > > Mine was 194g. The possibilities for a long driver occurred to me also, > but > > unfortunately that was not the project I had ordered it for. > > > > I also measured its face height at 52mm, much less than the 59mm claimed > in > > the specs. > > > > Which brings me to... > > There was a discussion a short while ago about whether the Mv2 has > specific > > slice or hook tendencies. (For instance, the Baltusrol has been reported > to > > slice a lot.) Have you noticed any? > > > > Thanks, > > DaveT > > > > > >
