Re: ShopTalk: Bad epoxy mix

[Ralph Harwood]

Jeremy, Since you mentioned Goo-gone, that was one of the products I used. I think back and now realize that I probably should have used an old toothbrush to clean it because these graphite shaft extenders are ribbed in the area that goes into the butt-end of the shaft. So it is quite possible that I may have been using the right products, just not the right method. Thanks! Ralph Jeremy Ingle wrote: Ralph the only thing I know is Alcohol other good cleaners are Polyclens or Goo-gone Ralph Harwood wrote: I had a bad mix of epoxy this weekend and had great trouble cleaning the graphite extender I was attempting to glue so I could start over. Could someone give me some ideas on what I could use to effectively remove the 'mess' ? Thanks! Ralph