RE: ShopTalk: Bad epoxy mix

Mon, 09 Feb 2004 15:29:53 -0800

Acetone will work but DO NOT use in on any plastic items, ferrels ect.  Same goes for laquer thinner.

 

Tom

 

-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Ralph Harwood
Sent: Monday, February 09, 2004 3:34 PM
To: [EMAIL PROTECTED]
Subject: Re: ShopTalk: Bad epoxy mix

 

Jeremy,

Since you mentioned Goo-gone, that was one of the products I used. I think back and now realize that I probably should have used an old toothbrush to clean it because these graphite shaft extenders are ribbed in the area that goes into the butt-end of the shaft. So it is quite possible that I may have been using the right products, just not the right method.

Thanks!
Ralph

Jeremy Ingle wrote:

 Ralph  the only thing I know is Alcohol  other good cleaners are Polyclens
or Goo-gone
Ralph Harwood wrote:
 
  


I had a bad mix of epoxy this weekend and had great trouble cleaning the
graphite extender I was attempting to glue so I
could start over.
 
Could someone give me some ideas on what I could use to effectively
remove the 'mess' ?
 
Thanks!
Ralph
    



 
 
 

Reply via email to