HI, Ralph
I use a solid rod long enough to ram the remaining epoxy out the
back of the shaft.
Ray
-----Original Message-----
From: Ralph Harwood [mailto:[EMAIL PROTECTED]
Sent: Monday, March 01, 2004 11:07 AM
To: ShopTalk
Subject: ShopTalk: cleaning out epoxy in a graphite shaft
I have a problem that maybe someone has an idea for me. I removed a
graphite shaft and am planning to use it on another head. I normally
clean out all epoxy from inside the shaft with a very small drill bit.
The drill bit I used is a very small one and is about 2 inches long. My
problem is that there is epoxy still in the shaft that my drill bit
cannot reach. I still have about an inch of epoxy to remove. My
question is whether there are small drill bits available that are at
least 3 inches long and still effectively work without breaking? Or is
there another solution I just have not thought of?
Thanks!
Ralph
