Ralph You could use a heet rod and try to melt it from the other end. or if you dont have one try using a steel knitting needle cut to say 4 " cut one end at an angle put the other end in your drill bit the angle cut should be sufficient to dis lodge the rest of the epoxy Let me know how you get on. Regards Jeremy
Ralph Harwood wrote: > I have a problem that maybe someone has an idea for me. I removed a > graphite shaft and am planning to use it on another head. I normally > clean out all epoxy from inside the shaft with a very small drill bit. > The drill bit I used is a very small one and is about 2 inches long. My > problem is that there is epoxy still in the shaft that my drill bit > cannot reach. I still have about an inch of epoxy to remove. My > question is whether there are small drill bits available that are at > least 3 inches long and still effectively work without breaking? Or is > there another solution I just have not thought of? > > Thanks! > Ralph
