If it's not a secret :-) Where can we get/buy this deal from or at ??
Jay ----- Original Message ----- From: "Ron Kellison" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Tuesday, January 31, 2006 10:50 PM Subject: ShopTalk: Apache iron shafts > Let's go back in time, shall we? > > I recently acquired a set of new Apache PM-30 iron shafts (R-flex) > for $4 per shaft. The deal was just too good to pass up! I plan to > put them into a new set of Wishon 770 heads later this winter. > I have a Club Scout 3 which I will use during fabrication, but at the > moment it and almost all of my other clubmaking tools are stored away > behind bags of > salt, shovels, ice chippers and the snow blower. > > I seem to remember someone on the Forum who was adamant that Apache > shafts played about 1 flex stiffer than their CPM readings. Does > anyone remember this > discussion and the concensus of opinion on the argument? If so, I > might build them a bit softer than I normally would. > > Regards, > > Ron >
