Hi,
I have a question regarding the asix-sigma and pulseview.
In pulseview, when I set an amount of samples and a frequency, for example 1M
Samples and 200kHz, and press the Run button, there will be 5 seconds of
sampling, and everything is fine - I can see the samples afterwards.
But when I press Run, and then Stop before the 5 seconds are over, nothing will
be shown.
Is this a problem of the driver or pulseview or is this by design?
The thing is - I do not always know before how long I have to do the sampling
... so I set the amount of samples to the highest reasonable time - for example
one minute ... but when I am able to reproduce the error I want to observe with
the logic analyser faster, so it happens after 10 seconds, I have to wait the
full minute to get results - this is kinda annoying
[cid:1500876215.4628.0.camel@evva.com]
Kind regards,
Michael Kaplan
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
sigrok-devel mailing list
sigrok-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/sigrok-devel
