Very interesting thread - nice to know that I'm not the only one to
think of it.
Sadly, given the environment I work in, doing it that way would work but
be rather time consuming :-(
My 16bit LA is based on the CY7C68013A module - and I note that there
are actually 3x 8bit channels available.
Has anyone produced firmware that can pass up all 3 ?? (PA, PB, PD) I
realize that this would cut the bandwidth from 12MHz down to 8MHz (??)
but it might be of some interest.
Many thanks for the replies
Dave
On 09/08/2020 17:12, Soeren Apel wrote:
Hello David,
You may want to check this thread:
https://www.mail-archive.com/sigrok-devel@lists.sourceforge.net/msg02674.html
Regards
-Soeren
On Sun, 2020-08-09 at 12:13 +0100, David Slipper wrote:
The other day I found myself in need of looking at an 18 wire bus.
Now I have a 16bit and an 8bit LA and I wondered if there was a way to
sample/record from both at the same time ??
As it happened I found that two of the signals could be safely ignored
but even so it struck me as a useful possibility.
I realise there may be problems and limitations with this but I wondered
if it might be possible ??
Best regards,
Dave
_______________________________________________
sigrok-devel mailing list
sigrok-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/sigrok-devel
.
_______________________________________________
sigrok-devel mailing list
sigrok-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/sigrok-devel
