> Mike, > From the recent discussions, I've gathered that the bulb actually > does not function as a current limiter, because 25 or 40 milliamps > (allowed by the commonly available small bulbs) is too high of a > current to produce 'desirable' CS production. (The bulb does > serve to indicate remaining battery strength, and to limit battery > drain in case of an electrode short circuit.) > Reports indicate that the desired smaller sized CS particles are > produced when using lower currents. So far, 8 milliamps seems to > be approximately the maximum desired current. I'm inferring > this from the following:
What a person could do is use a low frequency or no frequency to start that would give the high current needed then increase frequency with time and that would decrease the current. > Also, don't store the CS near electrical wiring, fuse boxes, > electric meters, motors, refrigerators, air conditioners, > electric stoves, electric heaters, speakers, magnets, > fluorescent light transformers, in-wall power cables, etc. > If you have an e/m field meter or detector, you could use it > to locate a 'quiet' CS storage place. > (Geomagnetic and geopathic fields may affect CS storage, also, > but callibrated field meters for measuring these are probably > very expensive....) You can pick up a real nice little EM field meter from Electronics goldmine for about $13. It's a well built device costing around $100+ when sold. Has about 12 LED's that increase as the EM field gets stronger. Take Care Reid -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the subject: line. To post, address your message to: [email protected] List maintainer: Mike Devour <[email protected]>
