Michael C McNeill wrote:
> 
> On Sat, 9 May 1998 12:41:05 -0500 "Gig A Watt" <[email protected]>
> writes:
> >
> >If there is chlorine it the water, you may be producing some
> >Silver Chloride.... and your CS may not be as pure as
> >Distilled Water would produce...
> >
> No worries there as Chlorine is one of the "contaminants" the system
> specifically filters out.  (if anyone would like more info about this
> water filter system, email me)
> 
> How long should I let the reaction go?  1 hour?  2? 3?
> 
> The "producing" wire turned gray on the submerged portion within a hour.
> I turned the wire over and stuck the other (still shiny) end back in the
> water.  How do I clean the wire?
> 
> wow!

Answers:

Use a penlight flashlight to check for good colloid.  Should look like
car headlights in fog.

I use an ohmmeter to check resistance of a sample in a 'measuring' lid
of a Listerine bottle that I keep it in. Mine is about 50 to 100K, but I
don't know the ppm of it. I use it to standardize the ppm of each batch
(whatever they actually are.)  Distilled water is over 1 Megohm.

You may wish to use only 3 batteries to get closer to the 30VDC
recommended 'best voltage', and add the 4th battery when the other three
run down a bit and are less energetic.

Dan Smith


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the subject: line.

To post, address your message to: [email protected]

List maintainer: Mike Devour <[email protected]>