Hi Kathryn, since your talking about D.C. current. As current passes from pole to pole. It passes the minerals too. Just wipe off eccess and switch polarity each time. Keeping current to less than 1 amp decreases particulant size. Voltage really doesn't matter. My Silver Puppy uses SWAP mode to achieve A.C. which does the same thing automaticly. Hope this helps. Just remember ohms law. Larry
--- On Sun, 10/18/09, Clayton Family <clay...@skypoint.com> wrote: From: Clayton Family <clay...@skypoint.com> Subject: Re: CS>Getting Started To: silver-list@eskimo.com Date: Sunday, October 18, 2009, 12:45 PM Sort of- it looks like your current may be on the high side, otherwise it would not be so much. It is normal- the water electrolyzes, the silver picks it up and it turns to the gunk you see. To control the amount of gunk, you can control the current more. That you can do with a resistor, diode or potentiometer in series. If you clip your wires to a multimeter set to measure milliamps, it should read zero when you start- that means there is no current flowing through the water to speak of. As the silver ions continue to go into the water, the conductivity increases and the current flow increases along with that. I forget what the details are (read formula is), but less than 1 mA current is a good idea if your silver surface area is under a certain - yours looks close to mine, and 1mA is what I am using. Just looking to see what the current is gives you some clues. I got a 75 ohm potentiometer at the surplus store and put it in series to keep a lid on the current. Maybe it was a dollar. Kathryn On Oct 18, 2009, at 1:38 PM, Jeff Maahs wrote: I'm getting a buildup of gunk on one of the rods. I haven't seen this on any of the videos or pictures. Is this normal? Here's an image if it helps: http://tinyurl.com/yfdskwb Thank you, Jeff
