Yes and that means that I use 1.5 gallons of water and it yeilds only .5 gallons after 6-8 hours of distilling.
I distilled first batch last night it read 2.8 while still warm however it read .7 this morning after it cooled and sat a while. I will continue to test the batches as they come out and as the distiller gets older it might change. I am on a water system which is not potable. (like being in a cottage) All of our drinking/cooking water is bought so it becomes quite a waste when I start tossing out a gallon of water each time. If it was just coming out of the tap I probably would not mind as much. 1.5 gallons of water and 6-8 hours power for 1/2 gallon also seem like a lot of waste. However I do understand that making the CS is what comes out cheaper in the end no matter what I do. :) I just dont understand how the temperature would make such a difference in the reading. 2.8 down to .7 is quite a difference. The PWT is suppose to take temp into consideration. Beth > This is on our site. > > Trem > > 1. Remove the carbon discharge filter. > It makes the water conductive. > > 2. Fill the boiling chamber no more than 3/4 > full. > > 3. Distill only 1/2 gallon into the receiver. > > 4. Discard the remainder in the boiling > chamber. > > 5. Repeat steps 2,3 and 4. You now have > one gallon in the receiver. > > 6. Put 3/4 gallon of this water in the boiling > chamber. > > 7. Distill only 1/2 gallon into the receiver. > > You now have what is called double distilled water. > > Allow to cool and try to use it. It should measure > less than 1 microsiemen > using a PWT meter.. > > > > ----- Original Message ----- > From: "Beth" <csilverl...@yahoo.ca> > To: "silver-list" <silver-list@eskimo.com> > Sent: Tuesday, November 02, 2010 9:05 PM > Subject: CS>distiller/ppm/hanna meter > > > > Okay so I did my first batch of water in the > distiller. > > No filter. > > I calaborated my hanna pwt to 84.0 as per solution > requirements. > > Then tested the first batch of distilled water. > > It reads 2.8 > > > > So is that because I have no filter? or maybe because > it is the > > first time I used the unit. I dont know. > > I will do another batch tomorrow and see what it comes > out to. > > > > It should be 0 to begin with right? > > > > Beth > > > > > -- The Silver List is a moderated forum for discussing Colloidal Silver. Rules and Instructions: http://www.silverlist.org Unsubscribe: <mailto:silver-list-requ...@eskimo.com?subject=unsubscribe> Archives: http://www.mail-archive.com/silver-list@eskimo.com/maillist.html Off-Topic discussions: <mailto:silver-off-topic-l...@eskimo.com> List Owner: Mike Devour <mailto:mdev...@eskimo.com>