Hi Asif, Welcome.
The anode current should be limited to less than 1 mA per square inch (1 mA per 645 mm^2 ). For fine results you could go much less than that, but going higher is bound to be rough on the electrode and to produce 'thingies' in the water. Contaminaton of the cell is most likely causing the particles, traces of detergent is the usual culprit there , as is wiping the electrodes with paper or cloth but anything that could float or fall in could be the problem. There are many variables : temperature, conductivity of the starting water, voltage across the cell, electrode distance apart, electrode aspect to each other. Nailing down as many as possible while varying just one will be very helpful while you are learning. Increasing temperature speeds up the reaction. Voltage vs Distance apart are sort of inverse proportion. current is proportional to particle size, sort of. Have fun, OK, Tony PS Archives: http://www.mail-archive.com/[email protected] They are not appearing at the bottom of your emails? Wonder why? Tony On 7 Jun 2011 at 0:18, Asif Nathekar wrote about : Subject : Re: CS>question regarding CS produc > Is 1.5ma too much..? > Is that why I got better results when I used 3 anodes? > Also is the silver width of 1.25mm ok? > -- The Silver List is a moderated forum for discussing Colloidal Silver. Rules and Instructions: http://www.silverlist.org Unsubscribe: <mailto:[email protected]?subject=unsubscribe> Archives: http://www.mail-archive.com/[email protected]/maillist.html Off-Topic discussions: <mailto:[email protected]> List Owner: Mike Devour <mailto:[email protected]>
