Sent from my iPhone
On 7 Jun 2011, at 16:05, "Tom Poast" <> wrote: > Hello Asif, > > While the electrode terminals on the SG6 are on 2 cm centers, the electrodes > are bent at the top at 90 degrees to make the connection. This brings the > electrodes out to the outside edge of the terminals. You end up with > electrodes that are spaced 4 cm in the water. > > Tom > > > -----Original Message----- > From: Asif Nathekar [mailto:[email protected]] > Sent: Monday, June 06, 2011 4:32 PM > To: [email protected] > Subject: Re: CS>question regarding CS production > > It takes about 2-3 hours to go to from 28 to 6v after which it starts > making "sludge" > I am thinking of buying my own distiller so that I can control the process > better. > > I have been brewing only 1 liter batches. I found a 300g coffee jar ideal. > Plus it was a glass jar. > I cannot increase the width of the electrodes any further than 3.5cm as I > have mounted them on the coffee jar lid. Which doesn't give me much real > estate after the motor on top. > > I understand that the silvergen SG6 has it's electrodes 2cm apart and uses 1 > ma. ( I remember from a trem's post) > > I have been wiping the electrodes every 20 mins. The cathodes get black > fairly quickly. > > Although things have improved by using 3 anodes. And distancing the > electrodes further to 3.5cm. They seem to make the brew more cleanly. > > I have run out distilled water. So I will not be able to tweak the setup > until then. > Also may I ask what voltage and current are you using for your setup? > > Sent from my iPhone > > > -- > The Silver List is a moderated forum for discussing Colloidal Silver. > Rules and Instructions: http://www.silverlist.org > > Unsubscribe: > <mailto:[email protected]?subject=unsubscribe> > Archives: > http://www.mail-archive.com/[email protected]/maillist.html > > Off-Topic discussions: <mailto:[email protected]> > List Owner: Mike Devour <mailto:[email protected]> > > >
