Hi Gail,

You wrote:

> Our batches are really pretty much clear.  I don't see "golden"
> tones at all.  Have we done something wrong or is clear ok?

As Chuck says, clear can be just fine. There are two ways your CS 
could be turning out clear: One you're only getting a few ppm, or 
two, you're generating smaller particles.

You said you were making quart sized batches, but it sounds like your
electrodes are pretty large surface area. I don't know which of those
is most important, so I can't guess which way it's going.

To find out try a simple experiment. Just run a batch for an extra
half-hour, hour, maybe two...? Decide as you go. If you start getting
a noticeable yellow tint, then what you're making is pretty typical
of the simple LVDC setups, and you're just pushing the ppm up towards
the 10ppm you've decided to try for. 

If it stays clear after that much more processing time, then I'd say
you might be getting small enough particles they don't reflect
visible light. It would be harder to guess the ppm.

In either case, you dose for results. If it's small particles, it'll 
probably take less to be effective. If it's 3 ppm instead of 10 ppm, 
it'll take more to get the same effect. Start small and ramp up the 
dose.

> > >Has anyone tried using CS for psoriasis, topically and/or internally?

We had a fellow who started taking it for psoriasis, both ways I 
think. He reported significant improvement, but kinda dropped out of 
sight before reporting the final results. Don't know if it cleared up
completely or not.

Let us know how you do.

Thanks, Chuck, and everyone for helping the new folks.

Mike D.
silver list owner

[Mike Devour, Citizen, Patriot, Libertarian]
[[email protected]                       ]
[Speaking only for myself...              ]


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]

List maintainer: Mike Devour <[email protected]>