Hello Gary,
The generators will sometimes not shut off on the HIGH setting because the water will not accept any more ions and it keeps turning them into colloids which are not conductive. Just turn the dial down until it shuts off and that’s the maximum setting for the water you’re using. Usually around 2-3 O:clock will be about right. I hope this helps you. Best regards, Trem Williams [email protected] www.silvergen.com From: Gary Hilt [mailto:[email protected]] Sent: Tuesday, September 30, 2014 12:42 PM To: [email protected] Subject: Re: CS>Testing CS Hello Trem: My silvergen will not shut offf after 3-4 hours using good ph distilled water. An suggestions. ThankYou On Tue, Sep 30, 2014 at 2:52 PM, TREM <[email protected]> wrote: Alan, The HI98308 is the PWT and it measures directly in PPM from .1 to 99.9 PPM TDS meters read in whole numbers and only read about 1/2 the silver so you double their readings. Trem -----Original Message----- From: Alan Faulkner [mailto:[email protected]] Sent: Tuesday, September 30, 2014 11:36 AM To: [email protected] Subject: CS>Testing CS I have a Hanna 98308 TDS meter. Is it accurate for testing CS PPM? Alan -- The Silver List is a moderated forum for discussing Colloidal Silver. Rules and Instructions: http://www.silverlist.org Unsubscribe: <mailto:[email protected]?subject=unsubscribe> Archives: http://www.mail-archive.com/[email protected]/maillist.html Off-Topic discussions: <mailto:[email protected]> List Owner: Mike Devour <mailto:[email protected]> -- Eph 1:2 Grace be to you, and peace, from God our Father, and from the Lord Jesus Christ. Gary & Lennie
