Hi Nina
all you have to do for your generator is to use a bottle with a plastic
cover..Make two holes for the silver rods in the cover..I fastened them
by using two stainless steel screws up through the cover and bend the silver
around them and tighten the nut outside ...The screw hole should be about
1/4 inch from the
hole for the silver ..then connect the batteries or power supply and you're
in business..
I keep the end of the silver about 1/4 of an inch from bottom of bottle.
separate the silver
about 1.5 inches.... Works fine.
Regards A.Rose
At 02:08 PM 6/3/00 -0400, you wrote:
Why is is important not to have the electrodes touch the sides or bottom?
Until I can set up another CS maker, I'm using an old unit that has worked
fine. The electrodes touch the sides and/or bottom of the glass pyrex
measuring cup in which I make the silver; and so far the silver has not
precipitated into large particles. It works, as evidenced by my immediate
response (eliminating colds etc).after ingestion.
Therefore, what is wrong with the electrodes touching the container in which
the silver is being made?
Nina
--
The silver-list is a moderated forum for discussion of colloidal silver.
To join or quit silver-list or silver-digest send an e-mail message to:
[email protected] -or- [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.
To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>
