Hi Vince, I appreciate you concern about safety.
We must use high voltage wire and bolt all connections using crimp on terminals where applicable. My set-up has a 3/8" brass center bolt drilled for a #14 silver wire with a allen head set screw in the hex head for retention. The back end of the bolt is slotted for screw drive adjust. If one were to adjust with power on then a GOOD grade of screw diver would be required. For those who have been following the construction; cut two pieces of the cpvc 1/2" pipe 2" long; cut one piece 1" long. On one of the 2" lengths glue on a coupling on one end and on the other a 90 deg elbow. The other 2" length one end is slotted or cross drilled at the end which will go into the dry ice chamber. This is to prevent the possibility of the dry ice from blocking the exit and creating a high pressure hazard. (bomb). On the other end of this piece glue on a 90 deg elbow. Use the 1" length to join the open ends of the two elbows. Make sure that things are lined up. The 2" pipe cap should be center drilled 5/8", you can use a spade drill if its sharp and drills an "on size" hole. Insert the slotted or cross drilled end into the end cap about 1/2" apply PVC cement on the out side of the end cap applying it on the pipe, and push the pipe in about 1/4" more. Glue up the chamber, and after it dries for a while run hot water through it several and let it sit over night. You do not want any glue smell in it. There will be another short length of 1/2" pipe required but will supply that data later. there is no need to glue that piece in as we might want to change it later. The reason for the offset is to stabilize the lid on the gallon jar. If anyone is desirous of making this project let me know off list so that I can make the lids. There is more time than material in them. More to come. "Ole Bob" -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>
