Unhook one of your silver rods from the power supply.
Connect the multimeter to the power suppy terminal you unhooked.
Connect the other multimeter lead to the silver wire you unhooked.
Make SURE your multimeter is set to read milliamps.
Don't be surprised if it reads 0 when you turn it on, it should increase within
several minutes.
Chuck
Go Lemmings Go!
On Mon, 19 Nov 2001 15:47:15 -0800, Ed Kasper <[email protected]> wrote:
>OK I bought one at Radio Shack for $15 a digital one
>
>NOW how do I use?
>
>Do I just put both the positive and negative ends in the water?
>- after I unplugged the unit...
>
>I am using 110VAC volts to a bridge rectifier the output I believe is 54
>VDC
>(2) 10 inches of wet silver (total 20 inches of wet silver) 5 inches apart
>mechanical stirrer in center (cheapest radio shack motor)
>
>one and half gallon distilled water
--
The silver-list is a moderated forum for discussion of colloidal silver.
To join or quit silver-list or silver-digest send an e-mail message to:
[email protected] -or- [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.
To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>
