Ed, Here is a picture of how to connect a multimeter into the CS making circuit. With that sort of voltage, Be Care Full. Switch off before touching anything. Standby and be prepared to switch off in a hurry in case you get connections wrong. Tony
Ed Kasper wrote:
OK I bought one at Radio Shack for $15 a digital one
NOW how do I use?
Do I just put both the positive and negative ends in the water?
- after I unplugged the unit...
I am using 110VAC volts to a bridge rectifier the output I believe is
54 VDC (2) 10 inches of wet silver (total 20 inches of wet silver) 5
inches apart mechanical stirrer in center (cheapest radio shack motor)
one and half gallon distilled water
sorry, I read earlier posts but I'm still confused about it.
Ed
Chuck wrote:
Unhook one of your silver rods from the power supply.
Connect the multimeter to the power suppy terminal you unhooked.
Connect the other multimeter lead to the silver wire you unhooked.
Make SURE your multimeter is set to read milliamps.
Don't be surprised if it reads 0 when you turn it on, it should
increase within several minutes.
Chuck
Go Lemmings Go!<<inline: silver_current_meter.jpg>>
