Hi Wayne, Our SG6 Auto and SG7 Pro both have a PPM control. It can be set from about 5 PPM to about 20 PPM. I occasionally set the calibration higher on special request.
It does not require a special tank (or volume ) to operate properly since the unit senses water conductivity to compare with the internal set point of the PPM dial and shuts down when they are the same. I use a 1.25 gallon container for calibrating the SG7 Pro's but supply a 5 gallon container with the unit. I have customers that use much larger production vessels. The generator just runs until the set point is reached. Trem ----- Original Message ----- From: "Wayne Fugitt" <[email protected]> To: <[email protected]> Sent: Tuesday, June 15, 2004 5:28 AM Subject: [silver_list] RE: CS>20 ppm CS > > > > > Both the silverpuppy and SG6 use conductivity feedback to tell when to > > shut themselves down, > > The logical thing to do is modify these units, or simply install a mode > stitch, manual / auto. > > It should not be hard to do, unless the units are poured full of epoxy. > > Or better yet, install a setting control where as one simply dials the > ppm. For this to work best, a specific tank size and a few other factors > would have to be uniform and controlled better than most amateurs would > want to do. > > These people are trying to leave the amateur class of brewers. > > IF there is a genuine need for this method, many people can design a unit > that will talk. > > I use a 4 channel voice chip that allows 4 each, 15 second messages. > > It could say....... > > The ppm is now 5 > > The ppm is now 10 > > The ppm is now 15 > > The ppm is now 20 > > > Wayne > > > > > -- > The Silver List is a moderated forum for discussing Colloidal Silver. > > Instructions for unsubscribing are posted at: http://silverlist.org > > To post, address your message to: [email protected] > Silver List archive: http://escribe.com/health/thesilverlist/index.html > > Address Off-Topic messages to: [email protected] > OT Archive: http://escribe.com/health/silverofftopiclist/index.html > > List maintainer: Mike Devour <[email protected]> > >
