3 nines and silver wire in a cup of tap water for an hour [Stans process] does not yield a low ending current. 10 PPM would probably be achieved in less than 5 minutes. At the end of an hour, the acceleration curve would be quite vertical maybe making 10 PPM per second... per second ...after the first half hour.. or even the first ten minutes?. [Just a guess] The rate of hydrogen and oxygen bubbles being emmited into the water would probably emulsify the mix which would later stratify into layers of black and brown sludge before crud starts falling out.
My very first attempt at making CS went like that. I was afraid to even pour it on the ground. I discarded the whole idea of using an uncontrolled process after that and started researching ways to get a handle on it and doing experiments to come up with the first reasonably 'good' generator I'd ever heard of. [based on experience as an electroplater with intense help from a world renouned electronics engineer ..my Dad.] That only took about 2 years of what is now pretty much common knowledge...on this list, anyhow. Apparently, Trem was doing the same thing at the same time...maybe a little faster than I. .. many thanks to Ole Bobs contributions along with several others on this list for inspiring various refinements... ..and no thanks to 'establishment' labs that returned results that were entirely inconsistant with each other, like, not EVEN close. Special thanks to Frank Key for setting me straight. [As painful as that was to discover that some elements are just plain crooked to some degree, no matter what, and the kinks have to be continuously worked around.] Thankfully, a fairly wide range of error is, at least, not dangerous. 3 nines and wire, used with common sense and caution, does just fine within that range of error. Essentially, if it looks like crap..it is. Toss it and try again with a little more caution. Just because caution and common sense is not 'built in' doesn't mean it's unavailable. Ode At 12:40 PM 7/2/2004 EDT, you wrote: >In a message dated 7/2/04 10:30:52 AM EST, [email protected] writes: > ><< > Stan Jones (the Senate-candidate with coffee-colored > > CS) dissolved silver wires into water using DC > > electricity. Isn't that *colloidal* silver? >> > >What I'm wondering is -- is there some problem with making Colloidal Silver >with DC electricity? I have made CS with AC to DC transformers, with >battery-operated units, and with generators made specifically for this purpose. As >long as the current level is low, and the water is distilled, don't they all make >usable Colloidal Silver? MA > > >-- >The Silver List is a moderated forum for discussing Colloidal Silver. > >Instructions for unsubscribing are posted at: http://silverlist.org > >To post, address your message to: [email protected] >Silver List archive: http://escribe.com/health/thesilverlist/index.html > >Address Off-Topic messages to: [email protected] >OT Archive: http://escribe.com/health/silverofftopiclist/index.html > >List maintainer: Mike Devour <[email protected]> > >
