Mouser Electronics www.mouser.com/centralsemi. You want a current regulator diode which you simply connect in series with one of the leads going to an electrode. They come in various current ratings starting at 0.22 mA on up to 4.7 mA. Some part part numbers are 610-1N52xx, where xx is 85 for .27 ma, 91 for 0.56 ma, 94 for 0.75 ma, 97 for 1.0 ma and 99 for 1.2 ma. You are better to go with less than one ma and let your generator run for a longer time; this yields smaller particles. Cost is about $2. --Steve Y.
----- Original Message ----- From: "Max Sanders" <[email protected]> To: "Silver-list" <[email protected]> Sent: Wednesday, March 01, 2006 7:30 AM Subject: CS>current regulating > I hope that no one minds my repost. I did not receive an answer to my inquiry and I am quite sure the answer lies within these borders.... > > "I have been using with success a funky Silver generator that does not have current regulation. I have come to use a magnetic stirrer for a long time now and that was a huge breakthru, then I added a voltage limiting X10 unit that I have to push a button to adjust. It works OK, but I have never added the current limiting diode that would keep the limit on my system. > > I may even have received this info before and I know it's been discussed mucho....but, what is the elec gizmo I need, where do I get it, and how is it installed?" > > Gracios, > > Maz > > --------------------------------- > Yahoo! Mail > Bring photos to life! New PhotoMail makes sharing a breeze. -- The Silver List is a moderated forum for discussing Colloidal Silver. Instructions for unsubscribing are posted at: http://silverlist.org To post, address your message to: [email protected] Address Off-Topic messages to: [email protected] The Silver List and Off Topic List archives are currently down... List maintainer: Mike Devour <[email protected]>
