am not exactly sure if it matters, whether the Cisco GW is configured
such that calls arriving at a given port are forwarded to the SIP phone
directly (i.e. the session target = ip address of the SIP phone) or to
the the sip registrar. By changing these values i am getting different
responses
-ms
[EMAIL PROTECTED] wrote:
moe,
As I understand you want SNOM to transfer POTS call to KPHONE?
If you are initiating call transfer from POTS, Cisco gw maybe performing blind transfer instead of attended call transfer. I am not sure if there is any configuration on Cisco which will allow you to do attended transfer.
Or, if initiating from SNOM, it can be an issue with SNOM doing blind transfer. In
this case you will have to check SNOM onfiguration.
-suheel
-----------------
Suheel Hussain
----- Original Message -----
From: "m. smadi" <[EMAIL PROTECTED]>
Date: Thursday, September 30, 2004 8:39 am
Subject: [Sip-implementors] CISCO router and SIP refer method
hi;
I have the following call:
SIP(SNOM) --> PSTN GW (CISCO) --> POTS destionation
I am asking the SNOM phone to issue a transfer to another SIP
Phone
(KPHONE), however i am loosing the connection with the POTS
destination
before i can establish a VOIP connection with the KPHONE. Now, is
there
a way to configure the CISCO box to swap the SIP leg of the SNOM
phone
with the newly established KPHONE leg without loosing the POTS leg?
thanks
moe smadi
_______________________________________________
Sip-implementors mailing list
[EMAIL PROTECTED]
http://lists.cs.columbia.edu/mailman/listinfo/sip-implementors
_______________________________________________
Sip-implementors mailing list
[EMAIL PROTECTED]
http://lists.cs.columbia.edu/mailman/listinfo/sip-implementors
