> Hi, > > In order to allow the Mediant1000/2000/3000 gateway to control the MWI > and Transfer Supplementary Services on a PRI-QSIG link I'm proposing > adding the following parameters to the Mediant INI file generated by > sipXconfig. These parameters are supported by the 5.0/5.2/5.4/5.6 > versions of the Mediant firmware. > > Please note that some of these parameters are already being sent to the > Audiocodes FXS gateways (as noted below): > > EnableMWI (default=0) Already exists for FXS, > controls sending of MWI > DefaultNumber (default=ServedUser) Default indicates MWI > destination will be controlled by NOTIFY contents > MwiSourceNumber (default blank) Controls calling number in PRI > SETUP > VoiceMailInterface (default=3, hidden) Default indicates PRI-QSIG MWI > > SubscriptionMode (default=1, hidden) Already exists for FXS, but we > want no MWI subscription on PRI > > TrunkTransferMode (default blank) Controls QSIG transfer > supplementary service > > > Any comments or suggestions? > Thanks... > Dave.
My only comment is it maybe good to think about how best to group/present these. I know you have a very specific application you plan on using these for... Maybe the screens can reflect this? instead of just adding more cryptic parameters to the Audiocodes it could be done in a way to enable the functionality you are developing. > > _______________________________________________ > sipx-dev mailing list [email protected] > List Archive: http://list.sipfoundry.org/archive/sipx-dev > Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev > sipXecs IP PBX -- http://www.sipfoundry.org/ _______________________________________________ sipx-dev mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-dev Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev sipXecs IP PBX -- http://www.sipfoundry.org/
