Saint, David (David) wrote:
Hi All
While configuring Mediant ( with firmware version -6.0) ,
under advanced parameters section there was a parameter
called 'Accepted IP Addresses'
in older firmware versions and with new f/w 6.0 its been
removed from that place. Please let us know where exactly the
entry corresponding to that should be made in config ui .
Thanks,
Madhu.
Hi Madhu,
In the 6.0 f/w the 'Accepted IP Addresses' are replaced with the
proxy addresses in 'PSTN to IP Call Routing', but please let
me know if you have a requirement to add additional accepted
addresses.
Dave.
With the 5.6 plugin of config ui using "Accepted IP Addresses"
available, it was possible to specify that
/Accepted IP Addresses = sut1.qantom.int sut2.qantom.int/. With this
setting it was possible to selectively route the calls using dialplans
in sut1 and sut2. Now is there a way to accomplish the same using 6.0
plugin of AC. If not, IMHO Accepted IP Addresses should be added..
Thank you ,
Naveen
_______________________________________________
sipx-dev mailing list [email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-dev
Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev
sipXecs IP PBX -- http://www.sipfoundry.org/
_______________________________________________
sipx-dev mailing list [email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-dev
Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-dev
sipXecs IP PBX -- http://www.sipfoundry.org/
