What you should do is use the mrtg built into sipxconfig. If yours is not sipx specific, I would undo it.
Then install via yum. Look under diagnostics to activate it. It should have installed with 4.x, you probably never went and enabled the checkboxes. ============================ Tony Graziano, Manager Telephone: 434.984.8430 Fax: 434.984.8431 Email: [email protected] LAN/Telephony/Security and Control Systems Helpdesk: Telephone: 434.984.8426 Fax: 434.984.8427 Helpdesk Contract Customers: http://www.myitdepartment.net/gethelp/ ----- Original Message ----- From: [email protected] <[email protected]> To: [email protected] <[email protected]> Sent: Sat Jan 16 17:26:59 2010 Subject: Re: [sipx-users] MRTG setup - bug in file from wiki? > On Jan 16, 2010, at 5:01 PM, Tony Graziano wrote: > Normally this would be yum install sipxconfig-mrtg Thanks Tony. That would have been good to know... Is there some way I should have known that? It's not mentioned on the Wiki page I was looking at. Thanks, Jeff _______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users sipXecs IP PBX -- http://www.sipfoundry.org/
