You build a custom dial plan that uses the first digits dialed as a filter, and then strip what you don't want to go out over a specified gateway.
As an example, if you wanted all calls to a 415 area code to go over Gateway NoCali, you would set the dial plan to look for anything that starts with 415 and then 7 digits to go over Gateway NoCali. In this case you wouldn't strip any digits, but you could have them dial 8 + 415 + 7 digits and strip the 8 in the dial plan. This is just a very rough example - because it is late and it's been a long day. Hope this helps. -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Roman Gelfand Sent: Sunday, October 10, 2010 1:17 PM To: Discussion list for users of sipXecs software Subject: Re: [sipx-users] Multiple SIP Trunking I am sorry, I meant where do you setup call routing based on destination phone number. On Sun, Oct 10, 2010 at 4:13 PM, Roman Gelfand <[email protected]> wrote: > Where do you configure routing based on caller id? > > Thanks for all the help > > On Sun, Oct 10, 2010 at 4:06 PM, Todd Hodgen <[email protected]> wrote: >> Sorry, meant caller id, not did - should have read - With regards to caller >> ID, you can set caller ID on a per user basis, or a group basis, or ITSP >> trunk basis, your choice. Provided of course that the ITSP supports it. >> >> -----Original Message----- >> From: [email protected] >> [mailto:[email protected]] On Behalf Of Todd Hodgen >> Sent: Sunday, October 10, 2010 1:02 PM >> To: 'Discussion list for users of sipXecs software' >> Subject: Re: [sipx-users] Multiple SIP Trunking >> >> With regards to sipXecs your impression is correct. If you have an ITSP >> that supports the SIP standards, you will be able to multiple DID numbers >> (many many) that termintate at an auto attendant, or multiple auto >> attendants, your choice, or as DID to specific stations, or specific hunt >> groups, your choice. >> >> With regards to DID, you can set DID on a per user basis, or group basis, or >> ITSP trunk basis, your choice. >> >> There are many good, qualified ITSPs that support these features and work >> great. >> >> Can't speak to the one you are using, but it appears they may be a >> challenge. >> >> -----Original Message----- >> From: [email protected] >> [mailto:[email protected]] On Behalf Of Roman Gelfand >> Sent: Sunday, October 10, 2010 12:16 PM >> To: [email protected] >> Subject: [sipx-users] Multiple SIP Trunking >> >> I was under the impression that multple phone number sip trunking is >> allowed with sipx. If I am not mistaken, I saw someplace that >> multiple phone numbres could receive incoming phone calls. Whereas, >> outgoing, you could have only one. If this is so, sipx doesn't allow >> me to add another gateway for sipxbridge-1. >> >> Could somebody clarify this. >> >> Thanks in advance >> _______________________________________________ >> sipx-users mailing list >> [email protected] >> List Archive: http://list.sipfoundry.org/archive/sipx-users/ >> >> _______________________________________________ >> sipx-users mailing list >> [email protected] >> List Archive: http://list.sipfoundry.org/archive/sipx-users/ >> >> _______________________________________________ >> sipx-users mailing list >> [email protected] >> List Archive: http://list.sipfoundry.org/archive/sipx-users/ >> > _______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users/ _______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users/
