Tony,
Thank you for your replies. I just recently rebuilt my outbound
configuration from Sipx to Cisco UCM using sipxbridge/siptrunk instead of an
unmanage gateway. I am now able to make outbound class using the ATA. So
this takes care of the SipX side which is being used by our office. The rest
of our campus is still on Cisco UCM directly.
When using a Granstream ATA directly with Cisco I still get the 481 error,
however, when I use a D-Link VG2001 with Cisco it works fine.
I am going to continue working on this. Hopefully I will hear back from
Grandstream at some point.
Jes
On Sun, Dec 5, 2010 at 3:59 PM, Tony Graziano
<[email protected]>wrote:
> I forgot to say my 286's dial out via sipxbridge/siptrunk without issue.
>
> The pcap makes it difficult to see any signalling inside sipx itself (i.e.,
> not a siptrace). All I see are the two ports used by each address. Other
> than making sure the path between the two devices follows an identical
> route, this is a SME issue.
>
> "The response that the CME is sending, is not received by the caller side.
> That is why it kept sending."
>
> On Sun, Dec 5, 2010 at 3:49 PM, Tony Graziano <
> [email protected]> wrote:
>
>> I have a couple of 486's from years ago. They keep losing
>> registrations and I have had the same experience with several
>> different versions of their firmware. They are unplugged (again), this
>> time for good. I also have a couple of 286's which I have no issues
>> with.
>>
>> I
>>
>> On 12/5/10, Becker, Jesse <[email protected]> wrote:
>> > All,
>> > My ticket has been opened with granstream for 5 days now and I have
>> not
>> > heard from them. Anyone have any ideas on why the 481 error is
>> happening?
>> > Have others had better luck with Grandstream support?
>> >
>> > Thanks,
>> >
>> > Jes
>> >
>> > On Wed, Dec 1, 2010 at 3:56 PM, Becker, Jesse <[email protected]
>> >wrote:
>> >
>> >> All,
>> >> I have opened a ticket with Grandstream for the 481 message I am
>> >> receiving. Has anyone else run into this before?
>> >>
>> >> Thanks,
>> >>
>> >> Jes
>> >>
>> >>
>> >> On Tue, Nov 30, 2010 at 11:02 AM, Becker, Jesse
>> >> <[email protected]>wrote:
>> >>
>> >>> All,
>> >>> I am having an issue where a Granstream Handytone 286 can call
>> other
>> >>> phones on the sipXecs system, however, it is unable to dial out via
>> the
>> >>> PSTN
>> >>> connection. During the call, the gateway sends a SIP update to the
>> >>> Handytone
>> >>> and it then responds with a 481 No Such Call.
>> >>>
>> >>> I have attached a zipped wireshark file. The call is from
>> >>> [email protected] and goes out to 818456875064. Our PSTN calls
>> go
>> >>> through Call Manager (setup as unmanaged gateway) and then through
>> call
>> >>> manager to a Cisco Router 2811 which has PRIs to PAETEC. Our Polycoms
>> >>> dial
>> >>> out via this method with no issues. Only the Granstream devices fails
>> >>> with a
>> >>> 481.
>> >>>
>> >>> Any advice would be appreciated.
>> >>>
>> >>> Jes
>> >>>
>> >>> --
>> >>>
>> >>> *Jesse Becker* | Technical Manager | CCNA, Linux+, Network+
>> >>> SUNY Ulster, 491 Cottekill Road, Stone Ridge, NY 12484
>> >>> Tel 845-687-5064 | Fax 845-687-5105
>> >>> [email protected] | www.sunyulster.edu
>> >>>
>> >>> Check out our knowledge base: http://kb.sunyulster.edu
>> >>>
>> >>>
>> >>
>> >>
>> >> --
>> >>
>> >> *Jesse Becker* | Technical Manager | CCNA, Linux+, Network+
>> >> SUNY Ulster, 491 Cottekill Road, Stone Ridge, NY 12484
>> >> Tel 845-687-5064 | Fax 845-687-5105
>> >> [email protected] | www.sunyulster.edu
>> >>
>> >> Check out our knowledge base: http://kb.sunyulster.edu
>> >>
>> >>
>> >
>> >
>> > --
>> >
>> > Jesse Becker | Technical Manager
>> > CCNA | Network+ | Linux+ Certified Professional
>> > SunGard Higher Education @ SUNY Ulster
>> > 491 Cottekill Road, Stone Ridge, NY 12484
>> > Tel 845-687-5064 | Fax 845-687-5105
>> > [email protected] | www.sunyulster.edu
>> >
>> > <http://www.sunyulster.edu/>
>> >
>> > Check out our knowledge base:
>> > http://kb.sunyulster.edu<http://kb.sunyulster.edu/>
>> >
>>
>> --
>> Sent from my mobile device
>>
>> ======================
>> Tony Graziano, Manager
>> Telephone: 434.984.8430
>> sip: [email protected]
>> Fax: 434.326.5325
>>
>> Email: [email protected]
>>
>> LAN/Telephony/Security and Control Systems Helpdesk:
>> Telephone: 434.984.8426
>> sip: [email protected]
>>
>> Helpdesk Contract Customers:
>> http://support.myitdepartment.net
>>
>> <http://support.myitdepartment.net>Blog:
>> http://blog.myitdepartment.net
>>
>> Linked-In Profile: http://www.linkedin.com/pub/tony-graziano/14/4a6/7a4
>>
>
>
>
> --
> ======================
> Tony Graziano, Manager
> Telephone: 434.984.8430
> sip: [email protected]
> Fax: 434.326.5325
>
> Email: [email protected]
>
> LAN/Telephony/Security and Control Systems Helpdesk:
> Telephone: 434.984.8426
> sip: [email protected]
>
> Helpdesk Contract Customers:
> http://support.myitdepartment.net
>
> <http://support.myitdepartment.net>Blog:
> http://blog.myitdepartment.net
>
> Linked-In Profile: http://www.linkedin.com/pub/tony-graziano/14/4a6/7a4
>
>
> _______________________________________________
> sipx-users mailing list
> [email protected]
> List Archive: http://list.sipfoundry.org/archive/sipx-users/
>
--
Jesse Becker | Technical Manager
CCNA | Network+ | Linux+ Certified Professional
SunGard Higher Education @ SUNY Ulster
491 Cottekill Road, Stone Ridge, NY 12484
Tel 845-687-5064 | Fax 845-687-5105
[email protected] | www.sunyulster.edu
<http://www.sunyulster.edu/>
Check out our knowledge base:
http://kb.sunyulster.edu<http://kb.sunyulster.edu/>
_______________________________________________
sipx-users mailing list
[email protected]
List Archive: http://list.sipfoundry.org/archive/sipx-users/
